Matters needing attention when vibrating screen is running
Check before running the vibrating screen: including equipment sanitation, complete, fastened, and intact connecting bolts at all parts, check whether the exciter is intact, check whether the springs are damaged, missing, or broken, and check whether the V-belt is tensioned or broken Whether the sieve box and sieve plate are damaged, check whether the sieve plate is blocked by debris, and the scre...
Introduction to the correct use of the crumbing machine
Operation and use of the crumbing machine:
(1) Preparation before starting up
1. Check the integrity and fastening of the parts, the fixing must be firm.
2. Check whether the wheel is locked firmly on the base.
3. Check the lubrication condition of the bearing.
(Two) boot
1. After the above inspection is completed, start the motor to run. use the proper amount of bread crumbs to run a ...
Introduction to some knowledge of vibrating screen
Vibrating screen is also called linear vibrating screen because of its linear motion, which is different from the circular vibrating screen that performs circular motion. The sand-gravel vibrating screen series produced by our company is a new type of high-yield screening equipment. It has a very good screening effect on the screening and classification of powdery and granular materials. It is sui...
About the daily maintenance of the vibrating screen
The vibrating screen needs maintenance to ensure its service life.
1. Carefully check whether the fastening bolts of each joint of the sieve machine are loose. If it is loose and continue to run, it will cause damage to the screen.
2. Whether the wiring from the vibration motor to the switch is worn or not, use neoprene vibration-resistant cables when replacing the cables. Operation with mis...
Correct steps for trial operation of vibrating screen
Many people don't know much about the test operation method of the vibrating screen, and do not know how to test it correctly.
1. Turn on the power switch and run it for 20-30 minutes. The motor should run counterclockwise under normal circumstances. If the direction is wrong, please adjust the three-phase power supply.
2. It should be confirmed that the vibration motor is running within...